EXHAUST PIPE (RIGHTSIDE) REPLACEMENT (Sheet 2 of 4)
Using adjustable wrench to hold elbow
(A), use 7/8 inch wrench and loosen
Using hammer, tap elbow (A) and lift
Using 9/16 inch socket and open end
wrench, remove six nuts (D) holding
exhaust pipe (E) to turbosupercharger
housing (F). Remove exhaust pipe (E)
with insulation halves (G) and gasket
(H) from turbosupercharger housing
(F). Throw gasket (H) away.
4. Using cross-tip screwdriver and
5/16 inch wrench, remove 14 screws
(J), each with two flat washers
(K), one lockwasher (L), and one
nut (M) holding insulation halves
(G) to exhaust pipe (E).
5. Using flat-tip screwdriver, remove
clamp (N) from packing (P). Remove
packing (P) from pipe (E).
6. Remove insulation halves (G) from
exhaust pipe (E).
Go on to Sheet 3