• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
HEU SLAVE RECEPTACLE REPLACEMENT - Continued
BULKHEAD CABLE DISCONNECT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  271    272    273    274    275  276  277    278    279    280    281  
img
. .
TM 5-5420-226-20-3
BULKHEAD CABLE DISCONNECT (Sheet 1 of 2)
TOOLS:
Spanner wrench
Flat-tip screwdriver
9/16 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
PRELIMINARY PROCEDURES:
Remove three ground straps from battery negative ter-
minals (page 10-268)
Remove commander's seat (page 17-78)
Remove right bulkhead access cover (page 17-2)
REMOVAL:
1.
Using 9/16 inch socket
remove seven screws (A) and lockwashers
(B) securing connector cover plate (C)
to bulkhead.
2.
Pull connector plate cover (C) and its
gasket (D) away from bulkhead. Harness
assemblies inside bulkhead will come
with cover plate (C) since they are
attached to it.
NOTE
To remove either of the two middle
connectors on the cover plate, you must
first remove either the top or bottom
connector, as required, to get a spanner
wrench on the desired connector.
3.
Using spanner wrench, disconnect and
remove connector (E) at back side of
cover plate (C).
4.
Using flat-tip screwdriver, remove four
screws (F) and lockwashers (G) securing
corresponding connector (H) and gasket
(J) at front side of cover plate (C).
Go on to Sheet 2
TA168920
10-269






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.