ENGINE STARTER WIRING HARNESS REPLACEMENT (Sheet 3 of 7)
5. Using 7/16 inch socket, remove eight
screws and four clamps (Q).
6. Using flat-tip screwdriver and 3/8 inch wrench
(S). Remove electrical connectors (T)
and (U) from connector bracket (V).
7. Disconnect electrical connectors (W)
8. Using 7/16 inch wrench to hold screw
and 7/16 inch socket on nut, remove
nut and screw (Y) and remove ground
wire (Z) from bracket.
9. Remove cables from engine.
Go on to Sheet 4