• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ENGINE WIRING HARNESS REPLACEMENT - Continued
ENGINE WIRING HARNESS REPLACEMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  295    296    297    298    299  300  301    302    303    304    305  
img
TM 5-5420-226-20-3
ENGINE WIRING HARNESS REPLACEMENT (Sheet 8 of 12)
2. Place cable (B) imposition on
starter (C) as shown.
3. Using flat-tip screwdriver, install
screw (D) securing cable (B) to
starter (C).
4. Place cable (E) in position on
starter solenoid (F).
5. Place two other cables(G) on starter
solenoid (F).
6. Using 3/4 inch wrench, install nut
and lockwasher (H).
7. Using spanner wrench, connect
connector (J) to low voltage
protection device (K).
8. Install two new plastic straps (L)
around cables (B, E and G).
Place connector (M) to ignition unit (N).
10. Place cable (P) and clamp (Q) in
position.
11. Using 7/16 inch socket, install two
screws and lockwashers (R) securing
cable (P) and clamp (Q).
Place clamp (S) (hidden) in position over
cables.
13. Using 1/2 inch socket, install nut
securing cables and clamp (S).
TA168944
Go on to Sheet 9
10-293






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.