• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
BASKET WIRING HARNESS DISCONNECT - Continued
POWER/MASTER CONTROL PANEL HARNESS REPLACEMENT

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  370    371    372    373    374  375  376    377    378    379    380  
img
.
TM 5-5420-202-3420-3
TM 5-5420-226-20-3
TM 5-5420-202-
BASKET WIRING HARNESS DISCONNECT (Sheet 4 of 4)
NOTE
The following instructions show
how to install the top wiring
connectors on the basket dis-
connect. Installation is the same
for all wiring harnesses.
NOTE
Check wiring diagram on sheet 3
for correct mating of connectors.
1.
Place connector (A) in proper position
with connector key at top on front side
of basket disconnect.
2.
Using flat-tip screwdriver, install four
screws and new lockwashers (B) securing
connector (A) to basket disconnect.
3.
Mate connector (C) onto connector
(A) at back side of basket disconnect.
4.
Using spanner wrench, tighten nut (D)
securing connector (C) on back side
of basket disconnect.
5.
Install other connectors as required
using the same procedure as steps 3
and 4.
6.
Connect three ground straps at batteries
(page 10-268).
End of Task
10-296.72
Change 6






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.