• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
DUST DETECTOR HULL INTERMEDIATE LEAD ASSEMBLY REPLACEMENT
DUST DETECTOR HULL INTERMEDIATE LEAD ASSEMBLY REPLACEMENT- Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  417    418    419    420    421  422  423    424    425    426    427  
img
TM 5-5420-226-20-3
DUST DETECTOR HULL INTERMEDUTE LEAD ASSEMBLY REPLACEMENT
(Sheet 2 of 4)
2.
Using slip joint pliers, unthread retaining
nut (C) from shell (D). Slide retaining nut
(C) back along cable.
Slide sleeving (E) back along lead assembly (F).
3.
4.
Slide bushing (G) back along cable.
Remove pin (H) from position "C" of insert (J).
5.
6.
Pull lead assembly (F) back through bushing (G) and retaining nut (C).
7.
Using socket, remove four screws (K),
lockwashers (L), and flat washers (M)
securing plate (N) to hull floor.
8.
Remove plate (N) from hull floor.
Using diagonal cutting pliers, cut tie wraps
9.
securing lead assembly (F) along smoke lead.
10.
Disconnect lead assembly connector (P) from
short lead (Q) on dust detector warning light
wiring harness.
11.
Remove hull intermediate lead assembly
(F) from vehicle.
Go on to Sheet 3
Change 1
10-298.9






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.