• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR - Continued
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  438    439    440    441    442  443  444    445    446    447    448  
img
. . .
TM 5-5420-226-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 5 of 18)
Male Connector Repair (Sheet 1 of 1)
Electrical connector repair tool kit
TOOLS:
Diagonal cutting pliers
SUPPLIES:
Silicone compound (Item 32. Appendix D)
Electrician's tape (Item 59, Appendix D)
PRELIMINARY PROCEDURES:
Disconnect three battery straps (page 10-268)
1. Slide shell (A) back along cable (B)
2. Using diagonal cutting pliers, cut
terminal (C) and C-washer (D) from cable
(B). Throw terminal (C) and C-washer (D)
away.
3. Using hand wire stripper, strip insulation
from cable (B) equal to well depth in
terminal (C).
4. Insert stripped cable end (E) into well in
terminal (C).
5. Using crimping tool, crimp terminal (C).
6. Push new C-washer (D) onto cable (B) at
rear of terminal (C).
7. Slide shell (A) forward along cable (B) until tight against C-washer (D).
8.
Using multimeter, check continuity of repaired circuit.
Connect three battery ground straps (page 10-268).
9.
End of Task
TA168953
10-302






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.