TM 5-5420-226-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 7 of 18)
Terminal Connector Repair (Sheet 2 of 2)
4. Slide new heat-shrink tubing (D)
onto and back along cable (C).
5. Slide new terminal (B) over stripped cable
end (E) and onto cable (C).
6. Using crimping tool, crimp terminal (B) at
7. Slide heat-shrink tubing (D)
over crimps (F and G).
8. Using heat gun, shrink tubing (D).
9. Using multimeter, check continuity of
repaired circuit.
10. Tighten or install cable clamps as required.
11. Connect three battery ground straps (page 10-268).
End of Task
TA168955
