TM 5-5420-226-20-3
SHIFTING CONTROL BRACKET AND LINK ASSEMBLY REPAIR (Sheet 6 of 11)
NOTE
If bearings (T) are to be
replaced, perform steps 14
and 15.
Using 1/8 inch punch and hammer, remove
14.
bearings (T).
Using vise, press two new bearings (T),
15.
one at a time, into link (R). Bearings
(T) must be flush with outer surface
of link (R).
INSPECTION:
Inspect bearings, washers,
and grease fitting for
wear or damage. Replace
as necessary.
TA169048
Go on to Sheet 7