NEUTRAL SHIFT SWITCH ADJUSTMENT (Sheet 3 of 3)
Lengthen screw (D) until meter just reads zero.
Lengthen screw (D) by three complete turns.
Using two wrenches, tighten jamnut (C)
toward bracket (E) while holding screw (D).
Set transmission lever to other positions;
meter should read zero in neutral "N" and
park "P" only. Replace neutral shift switch
Connect connectors (A) and
(B) to (C) and (D).
Test adjustment by attempting to start
engine in all transmission lever positions.
Engine should start only in neutral "N" and
park "P" positions.
Install transmission shroud (page 9-6).
End of Task