• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
FINAL DRIVE ADAPTER ASSEMBLY AND OIL SEAL REPLACEMENT
FINAL DRIVE ADAPTER ASSEMBLY AND OIL SEAL REPLACEMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  575    576    577    578    579  580  581    582    583    584    585  
img
.
TM 5-5420-226-20-3
FINAL DRIVE ADAPTER ASSEMBLY AND OIL SEAL REPLACEMENT (Sheet 2 of 2,
INSTALLATION:
1.
Positioned (A) in vehicle.
2.
Make sure that rubber lip of seal (A)
is toward inside of vehicle hull.
3.
Using hammer (B) and block of wood (C),
tap seal (A) into place.
NOTE
Seal is seated when tapped in as far as it will go.
4.
Make sure that all sand, grit, and accmulated
debris has been removed from the final drive
adapter assembly (D).
5.
Apply grease inside find drive adapter
assembly (D) and on find drive assembly
input shaft spline (E).
Using oil, lightly coat outside surface of final
6.
drive adapter assembly (D).
Alining internal splines in final drive adapter
7.
assembly (D) with splines on input shaft (E),
slide final drive adapter assembly (D) onto
input shaft and into seal (A).
a.
Install powerplant (page 5-14).
TA169114
End of Task
12-8






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.