• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
BRAKE MASTER CYLINDER REPLACEMENT - Continued
BRAKE MASTER CYLINDER REPLACEMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  609    610    611    612    613  614  615    616    617    618    619  
img
.
TM 5-5420-226-20-3
BRAKE MASTER CYLINDER REPLACEMENT (Sheet 6 of 9)
INSTALLATION :
1.
Using 1-1 /8 inch socket, remove filler
cap (A) from master cylinder (B).
CAUTION
Look inside the master cylinder (B)
through the filler cap hole (C) to the
bottom. The hole arrangement must
look like the pattern of holes shown
in (D). If not, install filler cap (A),
get the correct one, then repeat step 1
above.
2.
Get master cylinder ready for installation by removing all packing material, pipe plugs,
or plastic caps from ports (E) if installed. Clean as needed.
3.
Using fingers, install filler cap (A) to master cylinder (B) finger tight.
4.
Using 3/4 inch wrench, remove drain plug (F) and gasket (G) and relocate and install
at forward port (H).
Go on to Sheet 7
TA169137
13-7






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.