• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
BRAKE FOOT PEDAL LEVER MOUNTING BRACKET REPLACEMENT - Continued
BRAKE PEDAL ADJUSTMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  619    620    621    622    623  624  625    626    627    628    629  
img
. . . .
TM 5-5420-226-20-3
BRAKE PEDAL ADJUSTMENT (Sheet 1 of 2)
TOOLS: Pin, locating (1/2 in. dia., 7-1/2 in. long)
11/16 in. combination box and open end wrenches (two)
9/16 in. combination box and open end wrench
3/8 in. combination box and open end wrench
5/8 in. combination box and open end wrench
REFERENCE:
TM 5-5420-226-10
PRELIMINARY PROCEDURES:
Block tank tracks (TM 5-5420-226-10)
Set transmission shift lever to (N) neutral position
(TM 5-5420-226-10)
BRAKE PEDAL ADJUSTMENT:
1.
Depress brake pedal until hole in cam (A) is alined with hole in master cylinder bracket
(B). Insert locating pin through alinement holes in cam (A) and bracket (B).
2.
Using 11/16 inch wrench, loosen jam nuts (C) and (D), using 5/8 inch wrench adjust tie
rod (E) for a reading of 175 to 250 psi on pressure gage (F).
Tighten jamnuts (C) and (D).
3.
Remove locating pin installed in step 1.
4.
5.
Depress brake pedal until brake pedal cam face just contacts roller surface (G).
6.
Check pressure gage (F) for 0 psi reading.
Go on to Sheet 2
13-17






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.