MASTER BRAKE CYLINDER MOUNTING BRACKET, TIE ROD, PUSH ROD, CLEVIS, AND
BOOT REPLACEMENT (Sheet 4 of 9)
Using 7/16 inch socket and 7/16 inch
wrench, remove two screws (J), two
plate (M), and angle bracket (N).
Using hammer and punch, drive pin
Using pliers, pull pin (Q) out.
Using fingers, move clevis (R) to the left Remove two washers (S), roller assembly.
Remove push rod, tie rod, and clevis assembly (V) from bracket (G). Remove bracket (G)
Go on to Sheet 5