• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
MASTER BRAKE CYLINDER MOUNTING BRACKET, TIE ROD, PUSH ROD, CLEVIS, AND BOOT REPLACEMENT - Continued
MASTER BRAKE CYLINDER MOUNTING BRACKET, TIE ROD, PUSH ROD, CLEVIS, AND BOOT REPLACEMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  627    628    629    630    631  632  633    634    635    636    637  
img
.
TM 5-5420-226-20-3
MASTER BRAKE CYLINDER MOUNTING BRACKET, TIE ROD, PUSH CLEVIS AND
BOOT REPLACEMENT (Sheet 7 of 9)
INSTALLATION:
1.
Using vise with copper caps on vise
jaws, place clevis (A) in vise.
NOTE
Clevis (A) and nut (B) have left hand
threads. Nut (C) and push rod (E)
have right hand threads.
2.
Using 11/16 inch wrench, install nuts
(B) and (C) on tie rod (D) about 1-1/2
inches apart as shown.
NOTE
Nuts (B) and (C) will be tightened
during adjustment procedures.
3.
Using 5/8 inch wrench, assemble tie rod (D), push rod (E), and clevis (A).
4.
Apply adhesive to groove (F) on push rod (E). When adhesive becomes tacky to the touch,
install boot (G) with the drain hole in the lowest position.
5.
Remove clevis (A) and assembled parts (B), (C), (D), (E), and (G), from vise. Place bracket
(H) in vise. Install clevis (A) and assembled parts through hole in bracket as shown.
Go on to Sheet 8
TA169155
13-25






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.