MASTER BRAKE CYLINDER-TO-BULKHEAD TUBE ASSEMBLY REPLACEMENT (Sheet 2 of 5)
Using dry cleaning solvent and rags,
clean entire tube assembly and connec-
t ions at bulkhead and master cylinder.
Using hands, place funnel and container
under reducer (A) to catch draining
Get cap ready to install on reducer
to prevent e excessive loss of brake
Using 13/16 inch wrench to hold reducer
(A), use 11/16 inch wrench to turn tube
connecting nut (B). Cap reducer (A).
Place rags under union (C) at bulkhead to catch dripping brake fluid. Have
cap ready to place on nipple (D).
Using 7/8 inch wrench to hold nut (F), use 11/16 inch wrench to remove tube connecting
nut (E). Install cap on nipple (D).
Go on to Sheet 3