• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
BRAKE CONTROL HOUSING REPAIR - Continued
BRAKE CONTROL HOUSING REPAIR - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  672    673    674    675    676  677  678    679    680    681    682  
img
.
TM 5-5420-226-20-3
BRAKE CONTROL HOUSING REPAIR (Sheet 7 of 14)
CLEANING AND INSPECTION:
Cleaning agent specified is flammable.  Use only in well ventilated areas. Keep away from
flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes, mouth, and/or
skin. Wear rubber gloves when performing cleaning procedures.
1.
Clean all metallic parts in dry cleaning solvent.
2.
Inspect all parts for damage or wear.
Replace all unserviceable parts.
3.
INSTALLATION:
1.
Install stud (A) and eight studs (B) in
housing assembly (C).
Using 15/16 inch wrench, install plug
2.
(D) in housing assembly (C).
NOTE
If new transmission has been
installed, remove four nuts
and lockwashers from spacer
nut (E) locations, and two
screws and lockwashers from
stud (F) locations.
3.
Using 9/16 inch deep well socket, install
two studs (F). Using 9/16 inch socket
and torque wrench, tighten to 20-25 lb-ft
(27-34 N·m).
4.
Using 3/4 inch socket, install four spacer
nuts (E). Using 3/4 inch socket and-torque
wrench, tighten to 55-60 lb-ft (74-81
N·m).
Go on to Sheet 8
TA169194
13-70






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.