• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT - Continued
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  693    694    695    696    697  698  699    700    701    702    703  
img
TM 5-5420-226-20-3
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT (Sheet 2 of 17)
NOTE
Although the parking brake cable control assembly on the newer model
vehicles is a two piece cable and the older model vehicles (not yet mod-
ified) have a one piece cable, both are removed exactly the same way.
However, if only the two piece cable needs replacing go to steps 25
through 30 and step 34.  If complete two peice cable is to be removed
and replaced, use steps 1 through 34.
REMOVAL:
1.
Using pliers, remove cotter pin (A) and
straight headed pin (B) securing lever
(C) to clevis (D). Throw cotter pin (A)
away.
2.
Using pliers, remove cotter pin (E) and
straight headed pin (F) securing lever
(C) to base. Throw cotter pin (E) away.
Using hammer and 1/8 inch punch, drive
3.
out spring pin (H) from straight pin (J).
Using hammer and 1/4 inch punch, remove
straight pin (J) from lever (C) and base
(G). Throw spring pin (H) away.
Go on to Sheet 3
TA169215
13-91






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.