PARKING BRAKE CONTROL ASSEMBLY (ENGINE COMPARTMENT) REPLACEMENT (Sheet 7 of 15)
Using grease pencil, mark the distance
that both clevises (AV) are threaded
onto control assembly inner rods (AX).
Remove both clevises (AV).
Using fingers, remove nuts (AW).
Using 15/16 inch wrench, remove both nuts (AY).
Using 9/16 inch wrench to hold flats (AM and AZ) of control assemblies (F and S) and using
15/16 inch wrench, remove nuts (BA) and washers (BB).
Pull control assemblies (F and S) out of brackets (BC).
Using 15/16 inch wrench, remove washers (BD) and nuts (BE).
Go on to Sheet 8