PARKING BRAKE CONTROL ASSEMBLY (ENGINE COMPARTMENT) REPLACEMENT (Sheet 8 of 15)
Remove control assemblies (F and S).
Using 9/16 inch wrench On flats (AM
and AZ) of control assemblies (F and
S), use 15/16 inch wrench and remove
Using 9/16 inch wrench on flats (A and B) of
control assemblies (C and D), install both
nuts (E) at ends of control assemblies (C and
D) with cotter pin holes in threaded section.
Be sure nuts (E) are threaded all the way
onto threaded section.
Go on to Sheet 9