TM 5-5420-226-20-3
PARKING BRAKE CONTROL ASSEMBLY (ENGINE COMPARTMENT) REPLACEMENT (Sheet 11 of 15)
10.
Install nuts (R) and washers (S) over end of control assemblies (C and D). Thread nuts (R)
to ends of threaded sleeves.
11.
Insert ends of control assemblies (C and D) through brackets (T).
12.
Install washers (U) and nuts (V) onto control assemblies (C and D).
13.
Install new preformed packings into nuts (W) and install nuts (W) onto control assemblies
(C and D).
Using 9/16 inch wrench on flats (A and B) to hold, use 15/16 inch wrench and tighten
14.
nuts (W) until they cannot be tightened any more.
15.
Using two 15/16 inch wrenches, tighten nuts (R and V) to bracket (T).
TA169241
Go on to Sheet 12
13-117