PARKING BRAKE CABLE ADJUSTMENT (Sheet 2 of 4)
Using pliers, remove clip (E) and pin (F) holding brake cable (G) to bellcrank (H) at brake
controls bracket (J).
Rotate bellcrank (H) to aline holes in
bellcrank (H) with hole in brake controls
bracket (J). Insert 1/8 inch pin (K) trough
bellcrank (H) and bracket (J).
Pin (K) must slide up and down
freely while performing the
Push parking brake cable (G) inward until it stops.
Check forward end of cable at driver's compartment for free movement.
Go on to Sheet 3