• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
PARKING BRAKE PAWL AND BELLCRANK ADJUSTMENT
PARKING BRAKE PAWL AND BELLCRANK ADJUSTMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  733    734    735    736    737  738  739    740    741    742    743  
img
TM 5-5420-226-20-3
PARKING BRAKE PAWL AND BELLCRANK ADJUSTMENT (Sheet 2 of 4)
2.
Using pry bar, rotate bell crank (D)
counterclockwise to park position.
3.
Using pry bar between housing and
brake lever (E), force brake lever
(E) until first three teeth on brake
lever (E) are fully engaged with three
teeth on pawl (F).
NOTE
Observe during the following stepS
that some vechicles may have clips
rather than cotter pins.
Clips
should be reused and cotter pins
replaced.
4.
Using slip joint pliers, remove cotter
pin, washer, and pin (G) holding brake
cable clevis (H) to bell crank (D).
Throw cotter pin away.
TA169255
Go on to Sheet 3
13-131






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.