• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ROADWHEEL REPLACEMENT - Continued
HUB ASSEMBLY REPLACEMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  741    742    743    744    745  746  747    748    749    750    751  
img
. . . . . .
TM 5-5420-226-20-3
HUB ASSEMBLY REPLACEMENT (Sheet 1 of 7)
PROCEDURE INDEX
PAGE
PROCEDURE
14-6
Disassembly
14-8
Cleaning and Inspection
14-9
Assembly
9/16 in. socket with 1/2 in. drive
TOOLS:
Drift punch
Ratchet with 1/2 in. drive
Hammer
Hinged bar with 1/2 in. drive
2-1/2 in. socket with 3/4 in. drive
Ratchet with 3/4 in. drive
Pinch bar
Torque wrench with 3/4 in. drive (0-600 lb-ft) (0-814 N·m)
Long round nose pliers
SPECIAL TOOLS:
Face Wrench Socket (Item 28, Chapter 3, Section I)
Seal Inserter (Item 21, Chapter 3, Section 1)
Manual Control Handle (Item 11, Chapter 3, Section I)
Bearing Inserter Set (Item 17, Chapter 3, Section I)
Bearing Inserter Set (Item 16, Chapter 3, Section I)
SUPPLIES:
Grease (Item 37, Appendix D)
Gaskets
Seal
Bearing nut lock
Preformed packing
REFERENCES:
LO 5-5420-226-12
PRELIMINARY PROCEDURES:
Remove roadwheels (page 14-3).
DISASSEMBLY:
1. Using 9/16 inch socket, remove
six screws (A), lockwashers (B),
and washers (C).
2. Remove cover plate (D) and gasket
(E). Discard, gasket (E),
Go on to Sheet 2
14-6
Change 3






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.