• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
HUB AND ARM ASSEMBLY REPAIR
HUB AND ARM ASSEMBLY REPAIR - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  755    756    757    758    759  760  761    762    763    764    765  
img
.
TM 5-5420-226-20-3
HUB AND ARM ASSEMBLY REPAIR (Sheet 2 of 9)
DISASSEMBLY:
1.
Using pliers, bend key washer tabs back out of
slot in nut.
2.
Put spanner wrench on nut (A) so pins fit
into slots. Using spanner wrench and handle,
remove nut.
Remove key washer (B) and bearing washer (C).
3.
Discard bearing washer (C).
NOTE
Keep inner and outer races of bearings together as matched
set. If you throw away one race, throw away other one.
Use sleeve spacer (D) like a slide hammer to loosen inboard bearing (E). Remove bearing.
4.
Remove sleeve spacer (D) and outboard bearing (F).
5.
Pull oil seal retainer (G) off upper spindle (H).
6.
Go on to Sheet 3
14-20 Change 3






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.