TM 5-5420-226-20-3
TORSION BAR ANCHOR REPLACEMENT (Sheet 3 of 3)
13. Apply corrosion preventive to the inside of the
torsion bar anchor housing and solid film
lubricant to the torsion bar anchor.
14. Remove them, as necessary, tO repair
suspension system.
INSTALLATION:
Press two pins (A) into cover (B), if they were
1.
removed.
Install gasket (C) to cover (B).
2.
Position anchor (D) onto cover (B) so that two
3.
pins (A) fit into holes in anchor.
4.
Lift cover (B) and anchor (D) as an assembly.
Mount in roadwheel housing (E) opening.
Install four new lockwashers (F) and screws (G)
5.
to secure cover (B) to housing (E).
Using socket wrench, tighten four screws (G).
6.
Install torsion bar at opposite side of tank
7.
End of Task
14-35
Change 3
