• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
TRACK SUPPORT ROLLER REPLACEMENT - Continued
TRACK SUPPORT ROLLER ASSEMBLY REPAIR - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  786    787    788    789    790  791  792    793    794    795    796  
img
. . . .
TM 5-5420-226-20-3
TRACK SUPPORT ROLLER ASSEMBLY REPAIR (Sheet 1 of 4)
PROCEDURE INDEX
PAGE
PROCEDURE
14-46
Disassembly
14-49
Assembly
9/16 in. socket with 1/2 in. drive
TOOLS:
Ratchet with 1/2 in. drive
Sin. long extension with 1/2 in. drive
Ball peen hammer
Torque wrench with 1/2 in. drive 175 lb-ft capacity
Remover-replacer
SPECIAL TOOLS: Bearing inserter set (Item 17, Chapter 3, Section I)
Manual control handle (Item 12, Chapter 3, Section I)
Gloves (Item72, Appendix D)
SUPPLIES:
Grease (Item 37, Appendix D)
Dry cleaning solvent (Item 55, Appendix D)
Goggles (Item 71, Appendix D)
Rags (Item 65, Appendix D)
Remove track support roller assembly (page 14-36).
PRELIMINARY PROCEDURE:
DISASSEMBLY:
WARNING
Cleaning agent specified is flammable. Use only in well ventilated areas.
Keep away from flames, sparks, or heat. Do not smoke while using.
Prevent contact with eyes, mouth, and/or skin. Wear rubber gloves when
performing cleaning procedures.
CAUTION
Do not use dry cleaning solvent on rubber strips (A).
1.
Using dry cleaning solvent and rags, clean any grease or dirt on support roller assembly (B).
Go on to Sheet 2
14-46 Change 3






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.