TRACK ADJUSTING LINK REPAIR (Sheet 3 of 3)
Using hammer and punch, stake bearing (B)
into link (A) in three places (both sides).
Install bolt (C) and lockwasher (D) at other end
Using 9/16 inch wrench, tighten bolt (C) in
Using 7/16 inch wrench, install and tighten new
grease fitting (E) into position in link (A).
For easy access with grease gun, fitting (E) should be pointing outward
when link (A) is installed to vehicle.
Using grease gun, squirt grease through fitting (E) to make sure it is not plugged.
End of Task