STEERING CONTROL HANDLE, MOUNT AND SLEEVE REPLACEMENT (Sheet 2 of 2)
Using wrench, secure mount (A) to mounting
Install sleeve (D) in mount (A).
Using snap ring pliers, install retaining
ring (E) on sleeve (D).
Install all handle (F) over sleeve (D).
Line up holes in sleeve (D) and handle
Install all pin (G) in handle (F) and sleeve
Using slip joint pliers, install cotter
pin (H) through straight pin (G).
Insert rod end (J) into clevis of handle
Using wrench, install screw (K) to secure
rod end (J) to handle (F).
End of Task