STEERING CONTROL TO TRANSMISSION SHAFT CONNECTING LINK REPLACEMENT
(Sheet 1 of 2)
Torque wrench with 1/2 in. drive (0-175 lb-ft)
Slip joint pliers
9/16 in. socket with 1/2 in. drive
9/16 in. open end wrench (2 required)
PRELIMINARY PROCEDURES: Remove transmission shroud (page 9-2)
Using wrenches on bolt (A) and nut (B), remove nut (B) and bolt (A).
Using wrench on screw (C), remove screw (C).
Using pliers, remove cotter pin (D). Throw cotter pin (D) away.
Using wrench on nut (E), remove nut (E) and washer (F).
Remove link (G) from transmission stud (H).
Go on to Sheet 2