• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
STEERING CONTROL LINKAGE ADJUSTMENT - Continued
STEERING CONTROL LINKAGE ADJUSTMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  885    886    887    888    889  890  891    892    893    894    895  
img
TM 5-5420-226-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 8 of 22)
Using small gage wire, check to see if control
34.
rod (U) is into steering rod ends (R) and
(V) past witness holes. If control rod (U)
is past witness holes in both steering rod
ends (R) and (V), go on to step 49. If control
rod (U) is not past witness hole in steering
rod end (R), go on to step 35. If control
rod (U) is not past witness hole in steering
rod end (V), go on to step 45.
Using 9/16 inch wrench, turn steering rod
35.
end (R) clockwise until control rod (U) is
just past witness hole in steering rod end
(R).
36.
Using 9/16 inch wrench to hold steering
rod end (R), use 9/16 inch wrench to
tighten jamnut (T).
37.
Using 9/16 inch wrench, remove screw (W).
Position steering rod end (R) in clevis (S) and using 9/16 inch wrench, install screw
38.
(Q).
Using socket and torque wrench tighten screw (Q) to 16 lb-ft (22 N m).
39.
Go on to Sheet 9
TA169398
15-38






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.