• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
STEERING CONTROL LINKAGE ADJUSTMENT - Continued
STEERING CONTROL LINKAGE ADJUSTMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  893    894    895    896    897  898  899    900    901    902    903  
img
TM 5-5420-226 -20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 16 of 22)
Using small gage wire, check if control
84.
rod (AS) is past witness hole in steering
rod end (AT). If control rod (AS) is past
witness hole, go on to step 85. If control
rod (AS) is not past witness hole, go on to
step 88.
Using 9/16 inch wrench to hold steering
85.
rod end (AT), use 9/16 inch wrench to
tighten jamnut (AQ).
Position steering rod end (AT) in clevis
86.
(AU) and using 9/16 inch wrench, install
screw (AR).
Using socket and torque wrench, tighten screw (AR) to 16 lb-ft (22 N m).
87.
Go on to step 109.
Using 9/16 inch wrench, turn steering rod end (AT) clockwise until control rod (AS)
88.
is just past witness hole in steering rod end (AT).
Using 9/16 inch wrench to hold steering rod end (AT), use 9/16 inch wrench to tighten
89.
jamnut (AQ).
TA169406
Go on to Sheet 17
15-46






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.