REAR FENDER PLATE, SHIELD, AND SUPPORT REPLACEMENT (Sheet 5 of 5)
Place shield (M) in position on support
Install two washers (T) and screws (U).
Install five screws (V), 10 washers (W),
and five locknuts (X).
Using 9/16 inch wrench and 9/16 inch
socket, tighten all nuts and screws installed.
Place fender plate (Y) in position on support
plate (S) and outrigger (Z).
Using two 3/4 inch wrenches, install two
screws and locknuts (AA).
Install washers (AB) and locknuts (AC).
Place outer support (AB) on outrigger (Z)
studs and plate (Y).
Install two washers (AE) and locknuts (AF).
Install seven screws (AG),
14 washers (AH) and
seven locknuts (AJ).
Using 7/16 and 9/16 inch wrenches, tighten
all nuts and screws installed.
End of Task