OVERHEAD CYLINDER HOSE ASSEMBLIES (CL, CM, CN, AND CO) AND HYDRAULICS
REPLACEMENT (Sheet 3 of 8)
Holding bushing (Z) with 1-1/8 inch wrench, use 12 inch adjustable wrench to remove
elbow (X) from bushing (Z).
Holding regulator (AA) with 15 inch adjustable wrench, use 1-3/8 inch wrench to remove
bushing (Z) from regulator (AA).
Holding bushing (AB) with 1-3/8 inch wrench, use 15 inch adjustable wrench to remove
regulator (AA) from bushing (AB).
Holding nipple (AC) with 1-1/8 inch wrench, use 1-3/8 inch wrench to remove
bushing (AB) from nipple (AC).
Holding relief valve (AD) with 15 inch
adjustable wrench, use 1-1/8 inch wrench to
remove nipple (AC) from valve (AD).
Using 12 inch adjustable wrench, remove
elbow (AE) and attached nipple (AF) and
relief valve (AD) from overhead cylinder (U).
Using care not to cause damage, clamp
relief valve (AD) in vise.
Holding nipple (AF) with 1-1/8 inch
wrench, use 12 inch adjustable wrench
to remove elbow (AE) from nipple (AF).
Using 1-1/8 inch wrench, remove nipple (AF) from relief valve (AD).
Remove relief valve (AD) from vise.
Go on to Sheet 4