HOLD-DOWN CYLINDER ARMOR REPLACEMENT (Sheet 1 of 1)
3/4 in. combination box and open end wrench
3/4 in. socket with 1/2 in. drive
5 in. extension with 1/2 in. drive
Lockwashers (3 required)
Using socket on screw (A) and wrench on nut
(B), remove three screws (A), nuts (B), and
Lift armor (D) forward, then up, and remove from
Position armor (D) and slide rearward to
Insert three screws (A).
(B) on three screws (A).
Using socket on three screws (A) and wrench on nuts, tighten screws (A).
End of Task