• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
CUPOLA COVER HANDLES REPLACEMENT (LATE MODEL CUPOLA)
CUPOLA COVER SAFETY LATCH REPLACEMENT

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  174    175    176    177    178  179  180    181    182    183    184  
img
.
TM 5-5420-228-24
CUPOLA COVER HANDLES REPLACEMENT (LATE MODEL CUPOLA) (Sheet 2 of 2)
INSTALLATION:
1.
Manually slide outside handle
(A) through cupola cover (B),
Manually install woodruff key (C).
2.
NOTE
If only outside handle was replaced,
go to step 6.
Place hook (D) and shims (E), if any,
3.
in position on inside handle (F).
Manually install two screws (G).
4.
Using wrench, tighten two screws (G).
5.
Manually slide inside handle (F)
6.
into position on shaft of outside
handle (A).
Manually install lockwasher (H)
7.
and nut (J).
Using 15/1 6 inch socket, tighten
8.
nut (J).
From inside vehicle, close cupola cover (B).
9.
10.
Have second technician hold down cover (R) from outside of vehicle while
performing next step.
11.
Latch inside handle (F) to see that hook (D) properly contacts
locking lug (K) and seals cupola cover (B). If hook [D) does not contact lug (K)
or seal properly, add or remove shims (E) as needed between hook (D)
and reside handle (F).
End of Task
TA251423
3-22






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.