• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
OVERHEAD CYLINDER RELIEF VALVE (RV3) REPLACEMENT (Sheet 2 of 4)
OVERHEAD CYLINDER RELIEF VALVE (RV3) REPLACEMENT (Sheet 4 of 4)

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  259    260    261    262    263  264  265    266    267    268    269  
img
.
TM 5-5420-228-24
OVERHEAD CYLINDER RELIEF VALVE (RV3) REPLACEMENT (Sheet 3 of 4)
INSTALLATION:
NOTE
Remove all caps and plugs assecessary during instal-
Iation. Before installation, use pipe tape on all male
threads. Start tape on second thread so tape will not
enter hydrauIic system.
Using care to prevent damage, clamp relief valve "RV3" (A) in vise.
1.
NOTE
Locate and aline parts as shown in illustrations to
make sure connecting parts mate at final assembly.
Using 1-1/8 inch wrench, install
nipple (B) in relief valve (A).
Holding nipple (B) with 1-1/8 inch wrench,
3.
use an adjustable wrench to install elbow (C)
on nipple (B).
Using 1-1/4 inch wrench, install
4.
adapter (D) and collar "CM" (E) in
relief valve (A).
5.
Using adjust able wrench, install elbow (F) and collar "CO" (G) in relief valve (A).
Remove relief valve "RV3" (A) and attached
6.
parts from vise.
Using adjustable wrench, install elbow (C)
7.
with attached parts in rod end of cylinder
(H).
Go on to Sheet 4
TA251495
3-97






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.