• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
SEQUENCE AND LOCKING CYLINDER RELIEF VALVE (RV5 AND RV6) REPLACEMENT (Sheet 1 of 3)
SEQUENCE AND LOCKING CYLINDER RELIEF VALVE (RV5 AND RV6) REPLACEMENT (Sheet 3 of 3)

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  266    267    268    269    270  271  272    273    274    275    276  
img
.
TM 5-5420-228-24
SEQUENCE AND LOCKING CYLINDER RELIEF VALVE (RV5 AND RV6) REPLACEMENT
(Sheet 2 of 3)
6.
Holding screws (K) with 3/4 inch wrench, use socket
to remove four nuts (L) and lockwashers (M).
7.
Remove four screws (K) and bracket (N) with
manifold (P) attached.
8.
Using 1-1/8 inch wrench, remove two nipples (Q)
with relief valves "RV6" (R) and "RV5" (S)
from manifold (P).
Using vise to secure two relief valves (R)
9.
and (S), use 1-1/8 inch wrench to remove two
nipples (Q) from relief valves (R) and (S).
INSTALLATION:
NOTE
Before installation, use pipe tape on all male threads.
Start tape on second thread so tape will not enter
hydraulic system.
1.
Using 1-1/8 inch wrench, install two nipples
(A) in relief valves "RV6" (B) and "RV5"
(C).
2.
Using 1-1/8 inch wrench, install two nipples
(A) with relief valves (B) and (C) in
manifold (D).
Place bracket (E), with manifold (D)
3.
attached, in position in vehicle.
Manually install four screws (F), lockwashers
4.
(G), and nuts (H).
5.
Holding screws (F) with 3/4 inch wrench,
use socket to tighten four nuts (H).
Go on to Sheet 3
3-104






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.