• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
VALVE BANK ASSEMBLY CONTROLS REPLACEMENT (Sheet 2 of 2)
OVERHEAD CYLINDER HOSE ASSEMBLIES (CL, CM, CN, AND CO) AND HYDRAULICS REPLACEMENT (Sheet 2 of 8)

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  287    288    289    290    291  292  293    294    295    296    297  
img
. . . . . . . . . . .
TM 5-5420-228-24
Section III. FILTER, HOSE ASSEMBLIES, AND ASSOCIATED HYDRAULICS
OVERHEAD CYLINDER HOSE ASSEMBLIES (CL, CM, CN, AND CO) AND HYDRAULICS
REPLACEMENT (Sheet 1 of 8)
PROCEDURE INDEX
PROCEDURE
PAGE
3-125
Removal
Installation
3-129
TOOLS: 12 in. adjustable wrench
9/16 in. socket with 1/2 in. drive
1-1/4 in. open end wrench
Ratchet with 1/2 in. drive
1-1/8 in. open end wrench
Vise
1-3/8 in. open end wrench
15 in. adjustable wrench
Drip pans (suitable containers)
SUPPLIES:
Pencil (Item 22, Appendix D)
Rags (Item 12, Appendix D)
Pipe tape (Item 19, Appendix D)
Protective caps and plugs (assorted sizes)
Masking tape (Item 18, Appendix D)
Preformed packing (3 required)
Lockwashers (8 required)
REFERENCE:
LO 5-5420-202-12
PRELIMINARY PROCEDURES:
Remove overhead cylinder armor (page 3-223)
Remove front fixed and moveable hose armor (page 3-
133)
Relieve hydraulic pressure (page 3-71)
Use rags and drip pans to catch excess hydraulic fluid. Use masking tape to tag
lines for installation. Cap or plug all lines and fittings as they are disconnected.
1.
Holding elbow (A) with 12 inch adjustable wrench, use 1-1/4 inch wrench to disconnect
hose assembly (B) from elbow (A).
2.
Holding adapter (C) with 1-1/8 inch wrench, use 1-1/4 inch wrench to remove
hose assembly (B) from adapter (C).
Using 12 inch adjustable wrench, remove elbow (A) and collar (D) from relief valve (E).
3.
TA251523
Go on to Sheet 2
3-125






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.