• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
OVERHEAD CYLINDER HOSE ASSEMBLIES (CL, CM, CN, AND CO) AND HYDRAULICS REPLACEMENT (Sheet 4 of 8)
OVERHEAD CYLINDER HOSE ASSEMBLIES (CL, CM, CN, AND CO) AND HYDRAULICS REPLACEMENT (Sheet 6 of 8)

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  291    292    293    294    295  296  297    298    299    300    301  
img
.
TM 5-5420-228-24
OVERHEAD CYLINDER HOSE ASSEMBLIES (CL, CM, CN, AND CO) AND HYDRAULICS
REPLACEMENT (Sheet 5 of 8)
INSTALLATION:
NOTE
Remove all caps and plugs as necessary during installation. Before instal-
lation, use pipe tape on all male threads. Start tape on second thread so
tape will not enter hydraulic system. Locate and aline parts as shown in
illustrations to make sure connecting parts mate at final assembly.
Using care to prevent damage, clamp
1.
relief valve (A) in vise.
Using 1-1/8 inch wrench, install nipple
2.
(B) into valve (A).
Holding nipple (B) with 1-1/8 inch wrench,
3.
use 12 inch adjustable wrench to install
elbow (C) on nipple (B).
Using 1-1/8 inch wrench, install adapter (D) and collar (E) on relief valve (A).
4.
Using 12 inch adjustable wrench, install elbow (F) and collar (G) into relief valve (A).
5.
Remove relief valve (A) and attached parts from vise.
6.
7.
Using 12 inch adjustable wrench, install elbow (C) and attached parts on rod end of cylinder
(H).
Holding adapter (D) with 1-1/8 inch wrench, use 1-1/4 inch wrench to install hose assembly
8.
(J) on adapter (D).
Holding elbow (F) with 12 inch adjustable wrench, use 1-1/4 inch wrench to connect
9.
hose assembly (K) to elbow (F).
Go on to Sheet 6
TA251527
3-129






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.