• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
LOCKING CYLINDER HOSE ASSEMBLIES (EA1, CP3, CP4 and CS) AND HYDRAULICS REPLACEMENT (Sheet 1 of 4)
LOCKING CYLINDER HOSE ASSEMBLIES (EA1, CP3, CP4 and CS) AND HYDRAULICS REPLACEMENT (Sheet 3 of 4)

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  343    344    345    346    347  348  349    350    351    352    353  
img
.
TM 5-5420-228-24
LOCKING CYLINDER HOSE ASSEMBLIES (EA1, CP3, CP4 and CS) AND HYDRAULICS
REPLACEMENT (Sheet 2 of 4)
Holding tee (C) with adjustable wrench, use
6.
1-1/4 inch wrench to loosen nut (K).
Using adjustable wrench, remove tee (C),
7.
nut (K), flat washer (L), and preformed
packing (M). Throw preformed packing (M)
away.
Using 1-1/4 inch wrench, remove nut (H) and
8.
sleeve (N) as an assembly from tee (G).
Push sleeve (N) out of nut (H).
9.
Using adjustable wrench, remove tee (G), nut
10.
(P), flat washer (Q), and preformed packing
(R). Throw preformed packing (R) away.
11.
Using adjustable wrench on elbow (F) and
pipe wrench on coupling (S), remove elbow
(F).
12.
Using pipe wrench, remove coupling (S).
13.
Using adjustable wrench on elbows (T), use
7/8 inch wrench to remove hose assemblies
"CP3" (J) and "CP4" (D).
14.
Using adjustable wrench to hold elbows (T),
use 7/8 inch wrench to loosen nuts (U).
15.
Using adjustable wrench, remove two elbows
(T), nuts-(U), flat washers (V), and preformed
packings (W). Throw preformed packings
(W) away.
INSTALLATION:
NOTE
Before installation, use pipe tape on all male threads. Start tape on second thread
so tape will not enter hydrauIic system.
Go on to Sheet 3
TA251578
3-181






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.