• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
LOCKING CYLINDER HOSE ASSEMBLIES (EA1, CP3, CP4 and CS) AND HYDRAULICS REPLACEMENT (Sheet 4 of 4)
SCISSORS CYLINDER HOSE ASSEMBLIES (DAI AND DA2) AND HYDRAULICS REPLACEMENT (sheet 2 of 2)

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  346    347    348    349    350  351  352    353    354    355    356  
img
. . . . . . .
TM 5-5420-228-24
SCISSORS CYLINDER HOSE ASSEMBLIES (DAI AND DA2) AND HYDRAULICS REPLACEMENT
(sheet 1 of 2)
TOOLS: 1-1/4 in. open end wrench (2)
12 in. adjustable wrench
SUPPLIES:
Drip pans (suitable containers)
Rags (Item 12, Appendix D)
Pipe tape (Item 19, Appendix D)
Pencil (Item 22, Appendix D)
Masking tape (Item 18, Appendix D)
Preformed packings (4 required)
REFERENCE:
LO 5-5420-202-12
PRELIMINARY PROCEDURES:
Remove front quadrant (page 3-45)
Relieve hydraulic pressure (Page 3-71)
NOTE
Use rags and drip pans to catch excess hydraulic fluid. Use
masking tape to tag lines for installation.
Using 1-1/4 inch wrench on adapters (A), use
1.
1-1/4 inch wrench to disconnect hose
assemblies "DAl" (B) and "DA2" (C).
Using 1-1/4 inch wrench, remove two
2.
adapters (A) and preformed packings (D).
Throw preformed packings (D) away.
Go on to Sheet 2
TA251581
3-184






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.