• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
SCISSORS CYLINDER HOSE ASSEMBLIES (DAI AND DA2) AND HYDRAULICS REPLACEMENT (sheet 1 of 2)
VALVE BANK RETURN PORT FITTINGS REPLACEMENT (Sheet 1 of 3)

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  347    348    349    350    351  352  353    354    355    356    357  
img
. .
TM 5-5420-228-24
SCISSORS CYLINDER HOSE ASSEMBLIES (DA1 AND DA2) AND HYDRAULICS REPLACEMENT
(sheet 2 of 2)
3.
Using adjust able wrench on elbows (E), use
1-1/4 inch wrench to remove hose
assemblies "DA1" (B) and "DA2" (C).
4.
Using adjustable wrench to hold elbows (E),
use 1-1/4 inch wrench to loosen elbow nuts
(F).
Using adjustable wrench, remove two elbows
5.
(E), flat washers (G), nuts (F), and preformed
packings (H). Throw away preformed packings
NOTE
Before installation, use pipe tape on all male
threads. Start tape on second thread so tape
will not enter hydraulic system.
Using 1-1/4 inch wrench, install two
1.
adapters (A) and new preformed packings
(B).
Using 1-1/4 inch wrench on adapters (A),
2.
1-1/4 inch wrench to connect hose
assemblies "DAI" (C) and "DA2" (D).
3.
Manually install nuts (E), flat washers
(F), and new preformed packings (G) on elbows (H).
4.
Manually install two elbows (H) and
aline elbows.
Using adjustable wrench to hold elbows
5.
(H), use 1-1/4 inch wrench to tighten elbow
nuts (E).
Using adjustable wrench on elbows (H),
6.
use 1-1/4 inch wrench to install hose assemblies
"DAl" (C) and "DA2" (D).
Bleed hydraulic system (page 3-72).
7.
Check for hydraulic leaks and correct
8.
as necessary.
Install front quadrant (page 3-46).
9.
Service hydraulic reservoir (LO 5-5420-202-12).
10.
TA251582
End of Task
3-185






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.