TM 5-5420-228-24
VALVE BANK RETURN PORT FITTINGS REPLACEMENT (Sheet 2 of 3)
Using 1-1/4 inch wrench, remove hose
6.
assembly "CR" (H) from elbow (J).
7.
8.
9.
10.
11.
12*
Using 1-3/8 inch wrench, remove bushing (R)
from tee (G).
While holding nipple (S) with 1-3/8 inch wrench, use 12 inch adjustable wrench to remove
13.
tee (G) from nipple (S).
Using 1-3/8 inch wrench, remove nipple (S) from valve bank.
14.
INSTALLATION:
NOTE
Before installation, use pipe tape on all male threads. Start tape on second thread
so tape will not enter hydraulic system.
1.
Using 1-3/8 inch wrench, install nipple (A)
into valve bank.
2.
Using 1-3/8 inch wrench to hold nipple (A),
use 12 inch adjustable wrench to install tee
(B).
3.
Using 1-3/8 inch wrench, install bushing (C).
4.
Using 1-3/8 inch wrench to hold bushing (C),
use 1-1/8 inch wrench to install nipple (D).
5.
Holding nipple (D) with 1-1/8 inch wrench~
use 12 inch adjustable wrench to install tee
(E).
TA251584
Go on to Sheet 3
3-187