• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
HEU OR EARLY MODEL OVERHEAD CYLINDER REPAIR (Sheet 3 of 6)
HEU OR EARLY MODEL OVERHEAD CYLINDER REPAIR (Sheet 5 of 6)

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  479    480    481    482    483  484  485    486    487    488    489  
img
TM 5-5420-228-24
HEU OR EARLY MODEL OVERHEAD CYLINDER REPAIR (Sheet 4 of 6)
1. Using dry cleaning solvent, clean all metallic parts.
2. Using rags, dry all parts.
3. Inspect all parts for damage or wear. Replace all unserviceable parts.
ASSEMBLY:
For HEU: Position packing installation tool (A) on piston rod (B). Install new seal pack assembly (B.1) on
1.
piston rod (B) and push it into overhead cylinder (C). Remove packing installation tool (A).
For Early Model: Install new preformed packing assembly (B.1) on piston rod (B) and push it into overhead
cylinder (C).
2.
Install new spacer ring (D) (Early model) or retainer (D) (HEU) and new preformed packing (E) on land ring (F).
3.
Position land ring (F) on piston rod (B) and aline holes with overhead cylinder (C).
4.
Manually install eight screws (G) into land ring (F) and overhead cylinder (C).
5.
Using 1-5/16 inch socket and torque wrench, alternately tighten eight screws (G) to 320-330 lb-ft (440-445 N·m).
6.
Manually install new wiper ring (H) in land ring (F).
7.
Manually install four 10/32 screws (J) in threaded holes (K) of bushing (L).
8.
Using spanner wrench on screws (J), tighten bushing (L) against land rings (F).
9.
Manually remove screws (J) from bushing (L).
TA251722
Go on to Sheet 5
Change 3
3-230.5






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.