• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
EJECTION CYLINDER REPLACEMENT (RIGHT) (Sheet 2 of 4)
EJECTION CYLINDER REPLACEMENT (RIGHT) (Sheet 4 of 4)

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  510    511    512    513    514  515  516    517    518    519    520  
img
.
TM 5-5420-228-24
EJ ECT I ON CY LI N DER REPLACEM EN T (RI GH T ) (She e t 3 of 4 )
INSTALLATION:
Position ejection cylinder (A) in tongue (B).
1.
Manually install two screws (C) and
2.
lockwashers (D) in bottom of tongue to
secure ejection cylinder (A).
Using 1-1/2 inch wrench, tighten two screws
3.
(C) and lockwashers (D).
Manually start plug (E) on threads of
4.
cylinder rod (F).
Using punch in hole of plug (E),
5.
tighten plug (E) while holding
cylinder rod (F) from turning with
screwdriver.
NOTE
Before installation, use pipe tape on all male pipe threads. Start
tape on second thread so tape will not enter hydraulic system.
Remove all caps and plugs as necessary during installation.
Using 3/4 inch wrench, install nipple
(G) in ejection cylinder (A).
Using 3/4 inch wrench to hold nipple (G),
use adjustable wrench to install tee (H).
Manually place collars "CA" (J) and "CD"
(K) on elbows (L, M) and collar "CB" (N)
on elbow (P).
Manually install elbow (P) on ejection
cylinder (A) and elbows (L, M) on tee (H).
Using adjustable wrench, tighten elbows (L, M)
10.
to tee (H) and elbow (P) to ejection cylinder (A),
11.
Using 7/8 inch wrench, install hose
assemblies  "CA"  (Q),
"CB" (S) on elbows (L, M, P).
TA251640
Go on to Sheet 4
3-249






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.