• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
EJECTION CYLINDER REPLACEMENT (RIGHT) (Sheet 4 of 4)
HEU EJECTION CYLINDER (LEFT AND RIGHT) REPLACEMENT (Sheet 2 of 4)

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  512    513    514    515    516  517  518    519    520    521    522  
img
. . . . . . .
TM 5-5420-228-24
HEU EJECTION CYLINDER (LEFT AND RIGHT) REPLACEMENT (Sheet 1 of 4)
PROCEDURE INDEX
Procedures
Page
Removal
3-250.1
Installation
3-250.3
TOOLS:
3/8-in. drift punch
Sledge hammer
Flat-tip screwdriver (3/4 to 1 in. across flats)
10-in. adjustable wrench
3/4-in. open end wrench
1-1/2-in. open end wrench
7/8-in. open end wrench
SUPPLIES:
Pipe tape (Item 19, Appendix D)
Drip pans (suitable containers)
Pencil (Item 22, Appendix D)
Wooden block (make from Item 25, Appendix D)
Protective caps and plugs (assorted sizes)
Lockwashers (4 required)
Masking tape (Item 18, Appendix D)
O-Rings (4 required)
REFERENCE: LO-12
TM-10
PRELIMINARY PROCEDURES: Extend ejection cylinders (TM-10)
REMOVAL:
NOTE
·
Replacement of left or right ejection cylinder is similar; left cylinder replacement is
shown.
·
Use container to catch excess hydraulic fluid. Use masking tape to tag lines for installation.
Cap or plug all lines and fittings as they are disconnected.
1.
Place wooden block under tongue (A). Lower tongue (A) onto block (TM-10).
NOTE
It may be necessary to hit plug (B) with sledgehammer to loosen plug (B).
2.
Use punch in hole of plug (B) and unscrew
plug (B) while holding cylinder rod (C) from
turning with screwdriver.
3.
Remove plug (B) from tongue (A).
Go on to Sheet 2
Change 3
3-250.1






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.