• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Section Il. PUMP-CLUTCH AND VALVE BANK
PUMP-CLUTCH DRIVE REPLACEMENT (Sheet 3 of 4)

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  576    577    578    579    580  581  582    583    584    585    586  
img
.
TM 5-5420-228-24
PUMP-CLUTCH DRIVE REPLACEMENT (Sheet 2 of 4)
NOTE
Be careful to not lose key (E) When removing
pump-clutch drive (F) from clutch.
Slide pump-clutch drive (F) to rear out of clutch (A).
4.
Remove key (E).
5.
Take pump-clutch drive to shop area.
6.
Using snap ring pliers, remove two retaining rings (G).
7.
Using arbor press on long end of shaft (H),
8.
press shaft (H) and bearing (J) out of housing
(K).
Using arbor press, remove bearing (J) from shaft (H).
9.
10.
Using puller, remove bearing (L) from housing (K).
CLEANING AND INSPECTION:
WARNING
Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away
from flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes,
mouth, and/or skin. Wear rubber gloves when performing cleaning procedures.
1.
Clean all metallic parts with rags and
dry cleaning solvent.
TA251675
Go on to Sheet 3
4-24






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.