• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
HYDRAULIC PUMP REPAIR (Sheet 3 of 11)
HYDRAULIC PUMP REPAIR (Sheet 5 of 11)

Launcher Hydraulics System M48A5/M60A1 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 Page Navigation
  597    598    599    600    601  602  603    604    605    606    607  
img
TM 5-5420-228-24
HYDRAULIC PUMP REPAIR (Sheet 4 of 11)
NOTE
Do step 15
closely over a surface covered by rags.
Knuckles (T), flex bearing (U), and spring (V) may fall out
Rags will prevent
when cylinder block (Q) is removed.
impact damage to falling parts.
Have second technician slowly slip cylinder
15.
block (Q) off pistons (W) so pistons do
not strike each other and lay cylinder
block (Q) carefully on rag.
16.
Have second technician cap nine pistons (W)
with protective caps.
17.
Manually remove flex bearing (U) and
spring (V) from drive shaft (R).
Lay drive shaft (R) and attached parts carefull
18.
Remove universal link and pin assembly (X)
19.
f r o m cylinder block (Q). -
20.
Remove four knuckles (T) from link and pin
assembly (X).
Remove fixed bearing (Y) from fixed bearing
21.
retainer (Y).
Using pliers, press ears of retaining ring
22.
(M) together and remove retaining ring (Z)
and bearing retainer (Z) .
23.
Using screwdriver, remove screw (AB).
Manually remove washer (AC).
24.
TA251695
on to Sheet 5
GO
4-45






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.