VALVE BANK ASSEMBLY AND BRACKETS REPLACEMENT (Sheet 13 of 17)
Manually position identification
plates (AT) on valve bank (B).
Manually position two brackets (AU)
on valve bank (B) (one on each end).
Manually install four screws (AV),
lockwashers (AW), and nuts (AX).
Using 3/4 inch wrench to hold nuts
(AX), use 3/4 inch socket to tighten
Manually install two screws (AY), lockwashers (AZ), and nuts (BA).
Using 1/2 inch wrench to hold screw (AY), use 1/2 inch socket to tighten nut (BA).
Manually install two screws (BB), lockwashers (BC), and nuts (BD).
Using 7/16 inch wrench to hold screws (BB), use 7/16 inch socket to tighten nuts (BD).
Using second technician, position valve bank assembly (B) and brackets (AU) in vehicle.
Go on to Sheet 14